First of all there's two different ways I do it printing directly onto the fabric and using an iron on film. We'll do that one first.
I use t-shirt transfer film, which was created for people to add their own images onto t-shirts. I buy mine, for light backgrounds, from Wilkinsons.
As these are A4 in size, and what I usually want to print is smaller than that I add enough images on to fill the whole page to cut down on wastage.
One thing you MUST remember, if there's any writing or images that have to be a certain way around you need to print them in mirror image (you should be able to do this via the advanced properties section of the printer function on your computer). Once you've sorted that out print your image onto the plain side of the paper (it depends on your printer which way round you need to put the paper so that it does that, in mine, it's right-side up).
To use the image, cut it out of the one you want and place it face down onto the fabric you want to add it. Make sure your iron is on the next to hottest setting, and iron over the paper, making sure you keep the iron moving. After about a minute check a little corner to make sure that the image has started to come away from the paper. Pull the paper of in one go if you can, otherwise you'd leave kinks in the image.
The image on your fabric now is made from a film so putting a needle through it is hard and it leaves holes. A sewing machine will work though, but remember, if you make a mistake and have to unpick it, it will leave a hole.
|The image on this pillow is one printed onto film, ironed directly onto the fabric of the pillow. This rose pillow is available in my Folksy store.|
|This image has been printed onto white cotton that has been sewn onto the backing fabric. (This collage is available to buy in my Folksy store.|
I've used calico, cotton, hessian. You just need something that's not overly thick. A little bit if of trial and error will let you know how well your machine prints onto difference fabrics.
Cut out a piece of fabric and stick it to the card with the sellotape, making sure it is as smooth as possible. Trim the edges of the fabric, if necessary, so that it's exactly the same size as the card.
|A piece of fabric attached to the card ready for printing.|
|Images printed onto cotton.|
|Images printed onto rough linen.|
You can reuse the card with the tape on it for a few more time, you just have to make sure that it is still sticky enough to grip the fabric.
Now you can print onto fabric, your world is your oyster.
I'm taking oart in Handmade Monday, pop over to read what other makers have been up to here http://handmadeharbour.blogspot.co.uk/2013/04/handmade-monday-114.html